NewMar London Aire 2021, Руководство пользователя

Страница: 62 / 204

© 2020 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
57
CHASSIS
SYSTEM STATUS LED
In addition to the indicators on the touchscreen, there
is an LED on the surrounding bezel. The LED flashes or
remains steadily lit in green or red to provide information
on the leveling system status.
Auto Level Mode
Auto level mode automatically levels the vehicle using the
air suspension. The auto mode screen can be reached by
tapping Leveling.
When the Auto button is tapped on the auto mode
screen, the leveling system detects the lowest corner of
the vehicle, and then levels (lowers) the remaining corners
to it. If the system determines that it is unable to lower
the vehicle to level, any corners that are low will then be
raised to the level of the highest corner.
Because the Trueline Leveling System collects information
on the ground speed of the vehicle, the operational mode
may change automatically depending on the state of
the vehicle. For instance, in Manual Air mode, the coach
can be driven up to a speed of 5 mph, but if the speed
reaches 6 mph the operational mode will change to Travel
mode.
AUTO LEVEL MODE
Auto mode can be used to automatically level the vehicle
when the vehicle is stationary. This mode is the easiest
leveling method to use and is suitable for most leveling
situations.
MANUAL LEVEL MODE
Manual mode allows the operator to raise or lower each
corner of the vehicle individually using the air suspension.
Up to 2 corners can be operated at the same time.
•
Manual air mode can be used when the ignition is on
or o ff , and when the vehicle is traveling at low speeds
(up to 5 mph).
LEVEL INDICATOR
In manual mode and auto mode, the three level indicator
displays can be viewed as a builder’s level. The bubbles
move to the center once that axis is level.
USING AUTO LEVEL MODE
Ensure that:
•
The ignition is on and the air system is at full pressure.
•
The parking brake is engaged.
•
The front wheels are straightened.
1. Navigate to the Auto leveling screen.
•
Even though you are in the Auto mode screen,
the status at the bottom shows ‘Manual’ until you
actually tap the Auto button to begin the leveling
process.
2. Tap Auto to initiate a leveling cycle. The LED will
flash during auto leveling and turn solid when auto
leveling is finished.
3. At any time during the leveling process, it is
possible to stop by tapping the Stop button, or go
into Manual leveling mode by tapping the Manual
button.
•
Note: The sensitive leveling sensors require that
vehicle movement is kept to a minimum during
the leveling process. Therefore, if you are inside
the vehicle while it is leveling, please sit still or
walk lightly.
Press AUTO to initiate a leveling cycle. If the level
controller will not go into Auto mode it is most likely
because the vehicle’s parking brake has not been
applied, the vehicle is not in gear, or the ignition is o ff .
Ensure the ignition is on, apply the parking brake, and put
the transmission into neutral or park to allow the system
to enter Auto mode.
AUTO LEVELING CYCLE
The Trueline Leveling System begins by finding the
lowest corner of the vehicle. It then lowers the other three
corners until the vehicle is level. As the vehicle lowers, it
monitors the suspension height. If it reaches the minimum
height, it will stop lowering the high corners and begin
raising the low corners until the vehicle is level.
Once the auto leveling process completes, the vehicle
should be level and the system should go into low power
mode.