© 2020 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
152
INTERIOR
Entering Your Security Code
To enter your own security code you will need to follow
the steps listed below:
1. After installing the batteries,
locate the reset button on the
back of the door.
2. Press the reset button with a
pen and then release it; you will
hear a beep. Do NOT shut the
door until you have confirmed
that your new security code has
been entered correctly.
3. With the door open, enter
your own personal security
code, which can be 3-8 digits
long, and confirm your new code by pressing the
checkmark key on the electronic touch pad. You
will have 3 seconds to press the checkmark key,
otherwise you will have to start over from step one.
There will be 2 beeps (if the sound is turned on) and
the green light will flash twice if your code has been
entered successfully. Before you close the door, enter
the new security code and press the checkmark key
to make sure the lock releases the knob so you can
turn it and retract the live action locking bolts.
If the code fails, go through steps 1-3 again. If the code
works successfully, then you should lock the safe.
Note: The reset button located on the inside of the door
is covered with a removable cap. When you use the reset
button while setting your own combination, remove the
cap to access the button. Use the tip of a ballpoint pen or
the end tip of a paper clip to push the reset button.
Replace the cap securely over the reset button after
setting your combination. Failure to do so will compromise
the safety and security of the safe.
How to Operate a Retractable Step Cover
This article provides an operational overview of a retractable step cover. The Step Cover switch operates the step cover in
front of the passenger seat. Some models with mid-coach entry steps, may be equipped with a step cover, which operates
in the same manner.
1. Press the switch forward to extend the step cover to make it level with the coach floor.
2. Press the switch backward to lower and retract the cover in the stored position.
Safes
Stack-On Security Wall Safe Operation (Model:
PWS-1822E)
This article provides basic operation instructions for a Stack-On Security Wall Safe (Model: PWS-1822E).
Getting Started
When you first receive your new electronic safe you will
need to open the door with the key in order to install the
batteries. Batteries are included and are located inside
the safe.
This key can be found inside the coach information
packet. This is the black bag containing user manuals
and other coach-specific documentation. If the key
is not available, the default code set by the factory
is “1-5-9,” followed by the green checkmark button.
This code will only work if the batteries have already
been installed and a security code has NOT yet been
entered.
NOTICE
!
To open the door with the key, first remove the lock
cover from the front of the faceplate using a thin bladed
flathead screwdriver. Insert the key and turn left. Hold the
key in the open position and turn the knob to the right to
open the door.
Note: This key has been
provided in case you lose or
forget your security code or the
batteries run low. If you lose
your key, you may purchase a
replacement key by referencing
the serial number located under
the removable lock cover.
See the section at the end of
these instructions regarding
replacement keys.
Locate the batteries inside
the safe. Open the battery
compartment on the back of the
door by pushing the tab in the direction of the arrow and
install the batteries.
Содержание London Aire 2021
Страница 1: ...2021 sm...