Network Technologies VEEMUX SM-nXm-DVI-LCD, Инструкция по установке и эксплуатации

Страница: 17 / 61

NTI VEEMUX DVI VIDEO MATRIX SWITCH
12
Models SM-16X16-DVI-LCD and SM-32X32-DVI-LCD
The keypad control for the 16X16 and 32X32 models is very similar to that of the 8X8, with these differences:
•
The “In” and “Out” ports are selected by pressing the associated port number and then the “In” or “Out” button to
designate the video source or the display (respectively). Alternatively, the “In” or “Out” button can be pressed, then
the port number, followed by the “Enter” button.
•
Multiple displays can be connected to a single video source using one command sequence:
< In > xx< Out >xx< Out >xx< Out >xx< Out >xx< Enter > or
< Out >xx< Out >xx< Out >xx< Out >xx < In > xx < Enter > (where xx is the port number)
•
Within the “DDC” menu, “ Default 1 ”, “ default 2 ”, and “ From Out (?) will work as described on the previous page,
however the “ direct ” option is not applicable.
•
The main menu has two additional options, 5-Save Config and 6-Load Config, described below
•
The list of current connections shown on the LCD screen can be scrolled using the Up and Down Arrows , rather than
waiting for them to show the connection you are looking for.
Save and Load (Recall) Config
The SM-16X16-DVI-LCD and SM-32X32-DVI-LCD switches provide the ability to save and recall up to 100 switch
configurations using the LCD menu. The switch configurations define the current port connections, volume control settings, and
video blank status.
Note: The IRT-UNV IR Remote (page 49) can also be used to access these configurations by using the “SAVE” and
“RECALL” buttons.
To save a configuration, select “Save Config” from the main menu followed by a numeric button(s) (0-99) corresponding to
the memory slot the configuration is to be saved in. Press Enter after your selection to force the current configuration to
immediately be saved to the selected memory slot.
Configurations can be loaded (recalled) in much the same manner. To recall, select “Load Config” from the main menu
followed by the numeric button(s) (0-99) corresponding to the memory slot from which the configuration is to be recalled. Press
Enter after your selection to immediately force the switch to change the current switch configuration to match that of the
configuration recalled.