Network Technologies VEEMUX SM-nXm-DVI-LCD, Инструкция по установке и эксплуатации

Страница: 31 / 61

NTI VEEMUX DVI VIDEO MATRIX SWITCH
26
Telnet Interface-Port 2005
For a software control type of telnet interface session (versus operator telnet control through port 2000 as described on page 24),
connect to the VEEMUX through the current IP address at port 2005. Use the command set below to control and acquire
information from the VEEMUX.
Note: After establishing the connection, the unit will answer with a blinking prompt on the next line. If the connection
fails it will answer with ?<CR>
Legend
: (All numbers must be two digits)
OP
: Output Port (01-MAXOUTPUTS)
IP : Input Port (01-MAXINPUTS)
<CR> : Carriage Return (Hex 0xD)
Command Summary
Command String Good Response Description
RU<CR> ru I P, O P<CR> Read unit size
RO OP<CR> pc OP,IP<CR> Read connection for OP
CS I P, O P<CR>
*<CR> Connect OP to IP
CA IP<CR> *<CR> Connect all outputs to IP
SS 01<CR> *<CR> Enable auto-status mode
SS 00<CR> *<CR> Disable auto-status mode
SX<CR> See details Examine connections
AO OP<CR> ac OP,IP<CR> Read audio connection for OP
AS I P, O P<CR> *<CR> Connect audio OP to IP
AA IP<CR> *<CR> Connect all audio outputs to IP
AV OP,VV<CR> *<CR> Set audio volume for OP
AM OP,MM<CR> *<CR> Set audio mute status for OP
AR OP<CR> ar OP:MM,VV<CR> Read mute and volume for OP
XX<CR> *<CR> Close connection
Grayed commands are for models with audio option
A <CR> (carriage return, 0x0D) is considered to be the end of the command string. If a string exceeds 16 characters, an end of
string will be inserted automatically to avoid buffer overflow. An eventual <LF> (line feed, new line, 0x0A) after a <CR> will be
ignored. A bad string will always be responded to with the ASCII character
‘ ? ’ followed by a <CR>.
Note: Always be sure to terminate your telnet session with the <X> - <X> - <Enter> command string.