Advanced Settings
66
JNR1010v2 N150 Wireless Router
files and printers with any other wireless or wired computer or server that is connected to
a repeater.
Static Routes
Static routes provide more routing information to your router. Under usual circumstances, the
router has adequate routing information after it has been configured for Internet access, and
you do not need to configure more static routes. You must configure static routes only for
unusual cases such as multiple routers or multiple IP subnets on your network.
As an example of when a static route is needed, consider the following case:
•
Your primary Internet access is through a cable modem to an ISP.
•
You have an ISDN router on your home network for connecting to the company where
you are employed. This router’s address on your LAN is 192.168.1.100.
•
Your company’s network address is 134.177.0.0.
When you first configured your router, two implicit static routes were created. A default route
was created with your ISP as the gateway, and a second static route was created to your
local network for all 192.168.1.x addresses. With this configuration, if you attempt to access a
device on the 134.177.0.0 network, your router forwards your request to the ISP. The ISP
forwards your request to the company where you are employed, and the company’s firewall
denies the request.
In this case you must define a static route, telling your router that 134.177.0.0 should be
accessed through the ISDN router at 192.168.1.100. This example assume the following
settings:
•
The
Destination IP Address
and
IP Subnet Mask
fields specify that this static route
applies to all 134.177.x.x addresses.
•
The
Gateway IP Address
field specifies that all traffic for these addresses should be
forwarded to the ISDN router at 192.168.1.100.
•
A metric value of
1
works because the ISDN router is on the LAN.
•
Private
is selected only as a precautionary security measure in case RIP is activated.
To set up a static route:
1.
Log in to the router.
For more information, see
Log In to Your Router After Installation
on page
18.
2.
Select
ADVANCED > Advanced Setup > Static Routes
.
