NetApp StorageGRID SG5600 Series, Руководство по установке и обслуживанию оборудования

Страница: 28 / 73

Connect this port... To this port...
Port 2 on the E5600SG controller Service laptop, if not using DHCP
4. Connect the 10-GbE ports on the E5600SG controller to the appropriate network switches, using
optical cables and SFP+ transceivers.
• If you plan to use Fixed port bond mode (default), connect the ports to the StorageGRID Grid
and Client Networks, as shown in the table.
Port Connects to...
Port 1 Client Network (optional)
Port 2 Grid Network
Port 3 Client Network (optional)
Port 4 Grid Network
• If you plan to use the Aggregate port bond mode, connect one or more of the network ports to
one or more switches. You should connect at least two of the four ports to avoid having a
single point of failure. If you use more than one switch for a single LACP bond, the switches
must support MLAG or equivalent.
Related concepts
Port bond modes for the E5600SG controller ports on page 16
Related tasks
Accessing the StorageGRID Appliance Installer
on page 33
Connecting the AC power cords
You must connect the AC power cords to the external power source and to the AC power connector
on each controller. After you have connected the power cords, you can turn the power on.
Before you begin
Caution: Risk of electrical shock – Before connecting the power cords, make sure that the two
power switches on the appliance are off.
About this task
• You should use separate power sources for each power supply.
Connecting to independent power sources maintains power redundancy.
• You can use the power cords shipped with the controller with typical outlets used in the
destination country, such as wall receptacles of an uninterrupted power supply (UPS).
However, these power cords are not intended for use in most EIA-compliant cabinets.
Steps
1. Turn off the power switches in the enclosure or chassis.
2. Turn off the power switches on the controllers.
3. Connect the primary power cords from the cabinet to the external power sources.
28 | Hardware Installation and Maintenance Guide for SG5600 Appliances