Neptronic SK VAP, Инструкция по установке и эксплуатации

Страница: 16 / 36

16
Neptronic
®
www.neptronic.com
Evaporative Humidification / Cooling System
Step 6 - Connect Power Supply to SK VAP Control panel.
Warning: All work concerned with electrical installation MUST only be performed by skilled and qualified
technical personnel. (e.g. electrician or technicians with appropriate training). The customer
MUST be responsible for ensuring their suitability.
Please observe the local regulations concerning the provision of electrical installations.
Electrical Connections
An electrical power isolator (not supplied) must be fitted within 39” (1m) of the SK VAP Control panel. This is essential for
the purposes of maintenance and emergencies.
The electrical power cable to SK VAP Control panel should be suitably rated for a 120Vac / 10 Amp load in the US.
The power supply should be connected to the G, L and N terminals as shown in “wiring diagram” on page 17.
Step 7 - Connect SK VAP Module
Step 8 - Connect Controls
Connect the controls to the SK VAP control panel as shown in “wiring diagram” on page 17.
Warning: The SK VAP Panel and SK VAP Evaporative Module contain live mains voltage and MUST be isolat-
ed before commencing installation and maintenance work.
Once the SK VAP evaporative module and SK VAP control panel are installed, the cable should be cut to a suitable
length for installation and wired as shown in “wiring diagram” on page 17.