Nederman FlexPAK 800, Руководство по настройке

Страница: 9 / 44

FlexPAK 800/1000
9
EN
1 Preface
Read all product documentation and product identification plate carefully before
installation, use, and service of this product. Replace documentation immediately if lost.
Nederman reserves the right, without previous notice, to modify and improve its products
including documentation.
This product is designed to meet the requirements of relevant EU directives. To maintain
this status, all installation, maintenance, and repair is to be done by qualified personnel
using only Nederman original spare parts and accessories. Contact the nearest authorized
distributor or Nederman for advice on technical service and obtaining spare parts. If there
are any damaged or missing parts when the product is delivered, notify the carrier and the
local Nederman representative immediately.
(Include this when needed:
This manual is supplemented by an installation and service manual.)
2 Safety
This document contains important information that is presented as either a warning,
caution or note. See the following examples:
WARNING! Risk of personal injury.
Warnings indicate a potential hazard to the health and safety of personnel, and how that
hazard may be avoided.
CAUTION! Risk of equipment damage.
Cautions indicate a potential hazard to the product but not to personnel, and how that
hazard may be avoided.
NOTE! Notes contain other information that is important for personnel.
7.2 Filter cleaning in Standby mode
..................................................................................................................
37
7.3 Filter cleaning in Running mode
.................................................................................................................
37
7.4 Filter cleaning valve function
........................................................................................................................
37
8 ATEX Duct Isolation Valve settings
.............................................................................................................................
38
8.1 Flush Cycle settings
............................................................................................................................................
38
8.1.1 FlushCy1(T) (Timer)
................................................................................................................................
38
8.1.2 FlushCy2(T) (Timer) (Dual Function)
.............................................................................................
38
8.2 Tuning Duct Isolation Damper sequence
...............................................................................................
38
8.2.1 FCDely(T) Parameter
.............................................................................................................................
38
8.2.2 FCDely(T) Parameter Calculation See, Timing diagram
......................................................
39
8.2.3 Default FCDely(T) Parameter Settings
.........................................................................................
39
8.3 IsoVDly(T) Parameter Settings
......................................................................................................................
39
8.3.1 Default IsoVDly(T) Parameter Settings
........................................................................................
39
8.4 Default ClenCyl(T) Parameter Settings
....................................................................................................
39
8.4.1 Procedure to set ClenCyl(T) Parameter
......................................................................................
39
8.4.2 Settings TH = Cleaning Pulse Time (FC Valve opening Time)
..........................................
39
8.5 Total Filter Cleaning sequence time
..........................................................................................................
40
8.5.1 Settings TL = Vacuum Load Time
....................................................................................................
40
8.6 FC Start Impulse
...................................................................................................................................................
40
Appendix A: PLC setttings protocol .........................................................................................41