Necta Colibri, Руководство по установке, использованию и техническому обслуживанию

Страница: 13 / 48

9
© by NECTA VENDING SOLUTIONS SpA 01-2003 197 00
The machine installation and the following mainte-
nance operations should be carried out by qualified
personnel only, who are trained in the correct use of
the machine and are aware of the specific risks of
such operations.
The machine must be installed in a dry room with
temperature between 2°C and 32°C.
To energize the system with the open door, simply insert
the special key into the slot (see Fig. 6).
The door can be closed only after removing the key.
CONNECTING THE MACHINE
TO THE WATER MAINS
The machine must be connected to the drinking water
mains, taking into account law provisions in force in the
country where the machine is installed.
The water pressure must be 5 to 85 N/cm
2
(0.5-8.5 bar).
Run some water from the mains until it is clear and without
impurities.
Use a hose (also available as a kit) capable of withstand-
ing the water mains pressure and suitable for use with
foodstuff (min. inside diameter of 6 mm) to connect the
water supply to the union (3/4" gas) of the water inlet
solenoid valve (see Fig. 8).
Chapter 2
INSTALLATION
It is good practice to install the water supply tap
outside the machine in an easily accessible position.
OVERFLOW DEVICE
The water inlet solenoid valve (see Fig. 8) is equipped with
an overflow device which mechanically stops the water
inlet if there is a malfunction in the solenoid valve or in the
boiler water level control device.
To restore normal operation, proceed as follows:
- drain the water contained in the overflow hose;
- shut off the water supply using the tap outside the
machine;
- loosen the nut which secures the solenoid valve
supply hose to relieve the water mains residual
pressure and then tighten again (see Fig. 8);
- open the tap and switch the machine on.
At installation the hydraulic circuits and the parts in
contact with foodstuff should be fully sanitised to
remove any bacteria which might have formed during
storage.
UNPACKING THE VENDING MACHINE
After removing the packing, ensure that the machine is
intact.
If in doubt do not use the machine.
No packing elements (i.e. plastic bags, polystyrene
foam, nails, etc.) should be left within the reach of
children, as they are potentially dangerous.
Packing materials must be disposed of in authorised
containers and the recyclable ones must be recovered by
qualified companies.
Important notice!!
The machine should be positioned with a maximum incli-
nation of 2°.
If necessary provide proper levelling by way of the adjust-
able feet included (see Fig. 7).
Fig. 6
1 - Door lock bolt
2 - Door lock
3 - Door switch
Fig. 7
1 - Adjustable foot
Fig. 8
1 - Water inlet union (3/4" gas)
2 - Water supply hose
3 - Overflow hose