Necta Colibri, Руководство по установке, использованию и техническому обслуживанию

Страница: 23 / 48

19
© by NECTA VENDING SOLUTIONS SpA 01-2003 197 00
MACHINE CONFIGURATION
When the “Machine Config.” function is displayed, the
machine configuration can be changed, and namely:
- water supply from the mains / internal canister (tank)
- presence of warning device for full liquid waste container
(inside the cabinet)
- fast cycles ON / OFF
Press the confirm button “ ” to display the current status;
when pressing the correction button “ ” the status starts
blinking and can be changed with the “ ” and “ ” buttons.
IMPORTANT NOTICE!!!
When the machine is initialised, the configuration will
take on the default values: “Water supply from the
mains/without full waste container warning device/
fast cycles ON”.
THEREFORE, AFTER INITIALISING THE MACHINE
MUST BE RECONFIGURED.
OPERATION COUNTER
This function is used to lock the machine after a preset
number of coffee selections, and a preset number of
instant selections.
Since this is a control tool used only by the vending
operator, a 4-digit password must be entered.
After entering the password, it is possible to set the
number of selections after which the machine locks, read
the number of selections already made and reset the lock
counter.
N.B.: The counters are set to zero by default;
With the counters set to zero, this function is disabled.
SETTING THE PROMOTIONAL MESSAGE
When this menu is displayed, press the confirm button “ ”
to display whether or not the message is enabled (ON/
OFF).
If the message is enabled, when pressing the confirm
button “ ” the first character will start blinking and can be
changed.
The buttons will take on the following functions:
The values are displayed alternately by pressing the
button sequentially.
The message is stored by pressing button “2” when on the
last position.
LANGUAGE SELECTION
This function is used to select the language to be used for
displaying the messages.
The available languages are: Italian, French, Spanish and
English.
WHIPPING TIME
This function is used to define how long (in tenths of a
second) instant coffee is to be whipped according to the
amount of drink to be obtained.
PROGRAMMING ACCESS PASSWORD
This function is used to enable the request for a password
to access the programming procedures.
The password is the button sequence 1 1 2 2 and cannot
be changed.
SPECIAL SALES
This function is used to enable or disable Free Vend and
to set the number of consecutive instant drinks (1 to 9; 5
by default) that are dispensed when the “Jug facilities”
function is enabled.
After these functions are enabled, do as follows:
- while in normal operating mode, press button “8” for a few
seconds;
- enter the password that was just set;
- make a selection within 10 seconds.
TEMPERATURE SETTING
This function is used to set the operating temperature,
expressed in °C, of the boilers actually installed in the
machine.
PRE-GRINDING
This function is used to enable/disable grinding of the
coffee dose for the next selection. This permits the reduc-
tion of dispensing time for a coffee selection. The function
is disabled by default.
DIRECT FUNCTIONS
INSTALLATION
Press the installation button “3” to carry out the hydraulic
system filling operations, even with the air-break full.
RESETTING THE FAILURES
Press the failure reset button “8”; the message “Running”
is displayed for a few seconds and all present failures are
reset.
1 - Previous character
2 - Next character
3 - Upper/lower case