Necta Canto Plus Espresso, Установка, эксплуатация и обслуживание

Страница: 37 / 72

© by N&W GLOBAL VENDING S.p.A.
31
10 2009 3325 - 00
m
ixer
m
ixing mode
For every single selection you can set the duration of the
mixing cycle for every single water dose composing the
selection.
The duration can be set in two different modes:
absolute
i.e. not depending upon the start time of the pump.
The duration of the mixing cycle is set in tenths of a
second and it is calculated from the time the pump is
started up
relative
i.e. by way of difference, either in excess or in default,
compared to the stop time of the pump.
E.g.: if the value is 0, mixing will stop as soon as the
pump stops.
The duration of the mixing cycle is always expressed in
tenths of a second.
m
ixing speed
(
low
/
medium
/
high
)
You can define the mixing speed according to the prod -
uct quality you wish.
m
ixing Time
You can define how long the mixer shall be active after
the pump stop within one single product.
B
rewing parameTers
(fB
only
)
Parameters not available
w
aTer doses
To dispense water, act on the following parameters:
e
venT
s
TarT
(0 - 3)
Set this value to dispense the water of the relative ingre-
dient after the water with the lowest value.
In doing so, you can vary the sequence of the various
ingredients to get the best product quality.
d
elay
v
alue
You can set up the mixer delay (in hundredths of a sec-
ond) with respect to the pump start (event start)
d
ose in
cc
You can directly set up the water quantity you wish for
every single event start in cc.
d
ose in
cdv (
for espresso drinks only
)
You can directly set up the water quantity you wish
for the event start relative to an espresso drink in cdv
(strokes).
f
low raTe in cc
/
sec
.
You can set up the working speed of instant water
pumps to define the flow rate in cc/sec.
This value is used to calculate the time necessary to
dispense the dose in cc.
B
rewing Time
You can set the brewing time just for the selection of
reference of automatic grinding.
p
owder doses
To dispense powders, act on the following parameters:
d
ose in grams
You can directly set up the powder quantity you wish for
every single ingredient composing the drink in grams.
f
low raTe in gr
/
sec
.
You can set up the working speed of ingredient motors to
define the flow rate in gr/sec.
This value is used to calculate the time necessary to
dispense the dose in gr.
d
ecaff cycle or sTep dispensing
Use this function to establish for every single instant
coffee selection whether powder shall be dispensed ac -
cording to a decaff cycle or on a step basis, compared to
“global” setting.
- DECAFF CYCLE: use this parameter to dispense
powder before water to improve the drink quality (recom-
mended for instant coffee).
-STEP: use this parameter to dispense powder at inter-
vals (you can set up from 1 to 5) at the same time as
water.