4-10 Field Service Guidelines
Keyboard
Remove the keyboard from the system as follows.
1.
Use a rubber fingertip to release the two screw covers. There is one cover above
the
F1
and
F2
function keys and another above the
Prt Scr
and
Pause
keys.
2.
Remove two screws and a retainer on each side of the top edge of the keyboard.
3.
Use a screwdriver to gently lift the top edge of the keyboard up and towards the
VersaGlide while spreading the keyboard frame at or near the center on each
side of the keyboard.
4.
Disconnect the keyboard ribbon cable at CN17 on the Main board.
5.
Remove the keyboard from the system.
LCD and Top Cover Assembly
Remove the LCD by following the following instructions.
Hinge covers
Remove the two Hinge covers as follows:
1.
Open the LCD cover to 90 degrees.
2.
Apply pressure to the bottom inside surface of the hinge until the hide cover un-
seats. After both hinges covers are unseated open the LCD cover further and re-
move the hinge covers.
3.
Remove the two screw (one from each) hinge area. Disconnect the two LCD ca-
bles from CN11 and CN27 on the Main board.
4.
Close the LCD cover and turn the notebook over.
5.
Open the feet and remove two screws from under each foot.
6.
Remove 10 screws from the bottom.
7.
Turn over the notebook over and open and lift the LCD from the bottom assem-
bly carefully feeding the LCD cables through the opening in the keyboard surface.
8.
Remove one Screw which is in the top center of the keyboard opening
9.
Remove 4 screws under LCD.
10.
Remove 2 ribbon cables for sound board.
11.
Carefully feed LCD cables through opening in keyboard top cover.
