NEC Univerge SV8100 VM8000 InMail, Системное руководство

Страница: 19 / 388

VM8000 Issue 1.0
InMail System Guide 1 - 5
S
ECTION
5
B
ASIC
F
UNCTIONS WITHOUT
M
AIN
G
REETING
To make the VM8000 InMail answer, the following programming must be done. The
example shown is for a 8-port VM8000 InMail. Extension, Group and Pilot Numbers
shown can be adjusted as needed per installation requirements.
47-01-17 Set first port of In-Mail to 25, changing this PRG requires a CHS2U GW-US
reset.
10-09-01 Verify at least one resource is set to ICM/TRK or Common.
11-07-01 Set TEL Group Pilot 2 to 200.
Never use Group 1, as this is the default group for all extensions.
15-03-03 Set extension 125~128 to Special.
16-02-01 Put 125~128 in Group 2.
16-02-02 Assign priorities 1~4 to 125~128.
16-01-01 Set Group 2 name to VM Hunt.
16-01-04 Set Group 2 to Circular.
16-01-10 Set Group 2 to Busy/No Answer.
45-01-01 Set to Group 2.
S
ECTION
6
E
NABLE THE
M
AILBOXES FOR ALL
I
NSTALLED
E
XTENSIONS
Since by default only extensions 101-164 have Subscriber Mailboxes, you should
enable additional Subscriber Mailboxes for all installed extensions.
To enable additional Subscriber Mailboxes:
1. In 47-02-01 Mailbox Type, enter 1 to enable a Subscriber Mailbox for each
extension.
H
To make programming easier, consider associating a mailbox number with a station
port. For example, mailbox 1 should correspond to port 1, which in turn corresponds
to extension 101.
2. In 47-02-02 Mailbox Number, select the extension number to be associated with
the mailbox you are programming.
H Normally, mailbox 1 should use Mailbox Number 101, mailbox 2 should use Mailbox
Number 102, etc.
3. In 15-02-26 Message Key Operation Mode, enter 1 at each extension for which
you are adding a mailbox. This enables the Message key for Voice Mail access.