NEC PowerMate VP75, Руководство пользователя

Страница: 73 / 210

Setup and Operation 2-35
Changing Jumper Settings
To change system board jumper settings, use the following procedure. A label showing the
jumper information is inside the system unit cover. The label provides a quick reference for the
settings.
1. Turn off and unplug the system and any external options.
WARNING:
The system power must be off be-
fore changing a jumper setting.
2.
Remove the system unit cover (see Section 5).
3.
Locate the jumper(s) on the system board (see the figure under “Jumper Locations”
earlier in this section).
Some installed expansion boards may have to be removed to access the jumper (see
expansion board removal procedures in Section 6).
4.
If you removed any expansion boards, replace them.
5.
Replace the system unit cover (see Section 5).
6.
Plug in system and peripheral cables and turn on the system.
7.
Run Setup (see the Setup subsection earlier in this section).
CMOS Jumper
When clearing CMOS (JP8), use the following procedure.
1.
Perform steps 1 through 3 in the preceding procedure, “Changing Jumper Settings.”
2.
Install a jumper on jumper JP8.
3.
Power on the system for 5 seconds. The monitor will be blank.
4.
Power off the system.
5.
Remove the jumper from jumper JP8.
6.
Replace the system unit cover (see Section 5).
7.
Power on the system and run Setup.