3-28 Options
3.
Install the four device screws that were removed with the rails or that come with the kit,
two on each side of the device cage (see Figure Section 3-23).
Figure Section 3-23 Desktop 5 1/4-Inch Device Screws
4.
Cable the desktop 5 1/4-inch device as described next.
Desktop 5 1/4-Inch Diskette Drive Cabling
Cable an optional 5 1/4-inch diskette drive as follows. Adding a second diskette drive
requires an optional three-connector signal cable (part number 158-050561-000).
1.
Unplug and remove the two-connector signal cable from the installed diskette drive and
the diskette connector on the system board.
2.
Plug the optional three-connector cable into the system board and into the two diskette
drives (see Figure Section 3-24). The middle connector plugs into the 5 1/4-inch disk-
ette drive and the end connector plugs into the 3 1/2-inch drive.
NOTE:
When cabling the 5 1/4-inch device, note
that all power cables are keyed to fit only in the cor-
rect position. The red edge of the diskette drive sig-
nal cable is positioned as shown.
Содержание PowerMate VP75
Страница 147: ...Desktop Repair 5 21 ...
Страница 173: ...Minitower Repair 6 25 ...