Configuring the System 4-31
3.
Locate the Configuration jumper (J8A1) on the system
board (see “Locating the Jumper” in the previous
subsection).
4.
If necessary, remove any installed expansion boards to
access the jumper (see “Removing an Expansion Board”
in Chapter 5).
5.
Remove the jumper block from pins 1-2 and set it on pins
2-3. We recommend that you use needle nose pliers to
move a jumper.
6.
Replace the access cover (see “Replacing the Access
Cover” in Chapter 5).
7.
Connect system power cables and monitor.
8.
Power on the system.
The system enters Setup and the Maintenance menu
appears. You can disable the user and administrator
passwords.
If you removed the jumper, the system attempts to
recover the BIOS. A recovery diskette is needed.
9.
Power off, unplug the system and monitor, and remove
the access cover.
10.
Remove the jumper block from pins 2-3 and replace it on
pins 1-2.
11.
If you removed any expansion boards, replace them (see
“Installing an Expansion Board” in Chapter 5).
12.
Replace the access cover. Reconnect the system power
cables and peripheral devices.
13.
Power on the system.
14.
Run Setup (see “System BIOS and the Setup Utility” in
this chapter).
Содержание PowerMate SPB-Wash
