Disassembly and Reassembly 5-19
Replacement
To replace the system board, proceed as follows:
1.
Complete steps 1 through 11 in the previous subsection.
2.
Connect the system board and riser card.
3.
Place the system board and riser card assembly in the chassis.
4.
Attach the system board to the chassis with the six screws.
5.
Attach the riser card to the chassis with the three plastic rivets.
6.
Attach the IDE, main power, and fan power cables to the riser card.
7.
Reattach the top and bottom halves of the chassis (see “Closing the System
Chassis” in Section 3).
8.
Replace the front bezel (see “Front Bezel”).
9.
Replace the system unit top cover (see “System Unit Top Cover”).
10.
Connect the power cord and monitor and peripheral cables.
PCI Card
This subsection describes how to install a PCI expansion board.
CAUTION:
Only use half-length or smaller PCI
boards. Full-length boards do not fit in the
system.
To remove the system board, proceed as follows:
1.
Turn off the system and disconnect the power cord and all peripheral cables
connected to the system.
2.
Remove the system unit top cover (see “System Unit Top Cover”).
3.
Remove the front bezel (see “Front Bezel”).
4.
Separate the two halves of the chassis (see “Opening the System Chassis” in
Section 3).
5.
Remove retaining bracket (see Figure 5-15, A).
Save the bracket and screw for use in securing the expansion board.
6.
Remove filler panel (see Figure 5-15, B).
Содержание POWERMATE ENTERPRISE NETPC - SERVICE
Страница 6: ...Abbreviations xvii ...
