5-16 Disassembly and Reassembly
WARNING:
The microprocessor and heat sink
can be hot if the system has been running. Let
the heatsink cool before touching it.
Replacement
To replace a DIMM module, proceed as follows:
1.
Complete steps 1 through 4 in the previous subsection.
2.
Disengage the latches on an empty DIMM socket.
3.
Insert the DIMM into the socket. The latches pop up when the DIMM is fully
seated.
4.
Reattach the top and bottom halves of the chassis (see “Closing the System
Chassis” in Section 3).
5.
Replace the front bezel (see “Front Bezel”).
6.
Replace the system unit top cover (see “System Unit Top Cover”).
7.
Connect the power cord and monitor and peripheral cables.
System Board
This subsection describes how to remove and replace the system board.
Removal
To remove the system board, proceed as follows:
1.
Turn off the system and disconnect the power cord and all peripheral cables
connected to the system.
2.
Remove the system unit top cover (see “System Unit Top Cover”).
3.
Remove the front bezel (see “Front Bezel”).
4.
Separate the two halves of the chassis (see “Opening the System Chassis” in
Section 3).
5.
Disconnect the fan, power, and IDE connectors (see Figure 5-11).
6.
Remove the six screws attaching the system board to the bottom chassis (see
Figure 5-11).
Содержание POWERMATE ENTERPRISE NETPC - SERVICE
Страница 6: ...Abbreviations xvii ...
