NEC PowerMate eco, Инструкция по обслуживанию и справочник

Страница: 55 / 110

3-14 Disassembly and Reassembly
6.
Insert a small flat-head screwdriver at the pry point (
A
in the following figure) and carefully
pry up on the battery until it pops out of the socket.
Removing the CMOS Battery
A – Pry Point B – Battery
The battery can explode if it is incorrectly replaced or improperly
discarded. Use only the same type battery or an equivalent type recommended by the
manufacturer when replacing the battery.
Lithium acts as a catalyst when exposed to water and causes spontaneous combustion on
contact. Discard used batteries according to the manufacturer’s instructions.
7.
Remove the battery and discard it in accordance with the manufacturer’s instructions.
8. With the positive (+) side facing up, press the new battery into the socket.
9. After reassembling the system, run the BIOS Setup utility to reconfigure system parameters
according to the settings previously recorded (see Chapter 2, “Setup and Configuration”).