NEC POWERMATE 8100 RELEASE NOTES, Руководство пользователя

Страница: 94 / 277

Configuring the System 3-51
3. Locate the
J5G1
jumper block on the system board (see “System
Board Jumper Settings”). Move the jumper to pins 2 and 3. This
jumper setting brings the system up in Configure mode when it is
rebooted.
4. Replace the system unit cover (see “System Unit Cover”). Connect
system power cables and external options.
5.
Power on the system. The BIOS Setup utility launches immediately
after POST, and no password is required. The Maintenance menu is
active.
6.
Select the Clear All Passwords field. Press Enter .
7. A Setup Confirmation window appears with the prompt, “Clear All
Passwords Now?” The default is Yes. Press the left or right arrow
key to toggle between Yes and No. Select
Yes
and press
Enter
to
activate the choice.
8. Select the Exit menu with the left or right arrow key. Press
Enter
to
exit saving changes. Press
Enter
again to confirm that you wish to
exit the BIOS Setup utility.
9.
Power off and unplug the system and any external options. Remove
the system unit cover (see “System Unit Cover”).
10.
Move the J5G1 jumper back to pins 1 and 2 so the system can restart
in normal operation mode.
11. Replace the system unit cover (see “System Unit Cover”). Connect
system power cables and external options.
12. Power on the system and launch the BIOS Setup utility before POST
to set a new password (see “Setting a Password”) and recustomize
your BIOS settings.
Minitower Riser Board Jumper Settings
The minitower riser board has two jumper blocks that let you configure
the system as follows:
! enable or disable LAN on the riser board
!
configure the system for either a 2- or a 3-wire fan.
The following figure shows jumper locations on the riser board.