NEC MultiSync XG-1352C, Руководство по установке

Страница: 141 / 142

141
MASSAGE LIST
*INPUT DATE ERROR*
*INPUT TIME ERROR*
*KEY INPUT ERROR*
*NEW SIGNAL!!*
*PASSCODE ALREADY DISABLED!!*
*PICTURE MUTE ON!!*
*POINT DATA WRITE ERROR*
*POINT LIMIT OVER*
*SELECTED SCAN NUMBER IS NOT USED*
*SEQUENCER ABNORMAL END*
*SEQUENCER DATA ERROR*
*SEQUENCER END*
*SEQUENCER MANUAL END*
*STORING*
*THE PROJECTOR WILL TURN OFF SOON*
*THIS COLOR IS NOT APPLICABLE*
*WARNING ADDRESS!!*
*WARNING DIFFERENT PASSCODE!!*
*WARNING PASSCODE!!*
Date input mistake during the date and
time setting
Time input mistake during the date and
time setting
Key input is invalid.
An unregistered signal has been input.
Selection of PASSCODE DISABLE,
when the passcode has not be
registered.
R, G, B button is depressed at the time
of PICTURE MUTE setting
POINT DATA write error
POINT adjustment data are at a
maximum
Selection of an unregistered line on the
INPUT LIST
An error occurred while the SE-
QUENCER user program was running,
and the program was forced to stop.
POWER OFF or an INPUT command
was not set in the SEQUENCER user
program
AUTO SEQUENCER finished
There was a manual completion when
the AUTO SEQUENCER was running.
The gain data is being stored.
The projector will turn off in three
minutes when ON/OFF or SLEEP
TIMER is set to ON.
The selected tube was not on during
the gain adjustment.
Invalid PJ address input
Passcode input mistake
Invalid passcode input
Message
Conditions Countermeasures
Input in the form of MM:DD:YY
Input in the form of HH:MM:SS (24
hours)
Input the correct key.
Signal registration
-
Cancel PICTURE MUTE
*
Reduce the correction data, combine
other adjustments, and adjust.
Select a registered line.
Reset the SEQUENCER.
Reset the SEQUENCER.
-
-
-
Disable or change the timer.
Switch on the adjustment tube.
Input 01 to 64
Input the registered passcode.
0000 and 9999 cannot be used
*
Please contact service personnel if there are frequent occurrences.