NEC Express5800/180Rb-7, Руководство пользователя

Страница: 82 / 196

3-24 Configuring Your System
Launching a Task
It is possible to have many tasks open at the same time, although some tasks
might require complete control to avoid possible conflicts. A task achieves
complete control by commanding the center of operation until you close the task
window.
To launch a task:
!
In the SSU Main window, double-click the task name under Available
Tasks to display the main window for that task, OR
!
Highlight the task name, and click <OK>, OR
!
Use the tab and arrow keys to highlight the desired button, and press the
spacebar or <Enter>.
Resource Configuration Add-in (RCA) Window
The RCA provides three major functions:
!
Creates representations of devices that cannot be discovered by the
system.
!
Modifies the contents of the system by adding and removing devices.
!
Modifies the resources used by devices.
1.
From the SSU main window, launch the RCA by selecting the “Resources”
task under the RCA heading in the task box.
2. When the RCA window appears, it displays messages similar to the
following:
Baseboard: System Board
PCI Card: Bus 00 dev 00 -– Host Processor Bridge
PCI Card: Bus 00 dev 0D –- Multifunction Controller
PCI Card: Bus 00 dev 0F –- Ethernet Controller
PCI Card: Bus 00 dev 12 –- Multifunction Controller
PCI Card: Bus 00 dev 14 –- VGA Controller
3.
To configure a device, click it or select its name in the Devices section of the
RCA window, and press the spacebar or <Enter>.
4. You can close the RCA window and return to the AF by clicking on the
Close button. Any changes made will be kept in memory for use by the
RCA when it is rerun.
5.
Save all changes by clicking <Save>. Saving writes your current
configuration to nonvolatile storage where it will be available to the system
after every reboot.
6. To discard all changes, close the window by clicking on the system menu
(the dash in the upper-left corner). Do not do this if you want to save
changes (step 5).