2-24 Setting Up Your System
Installing the Center Rail
Follow the procedure below to install the center rail.
1.
Fully extend the rails until they lock in place.
2.
While pressing down on the safety latch, slide the rails to remove the center rail (smallest
rail).
3.
Position the rail. Ensure the safety latch is pointed towards the front of the server.
Align the screw holes of the rail with the upper row of screw holes on the chassis.
4.
Fix the center rail with four screws (B).
Safety latch
Lower row of screw holes
Screws
5.
Repeat steps 1 through 4 for the other rail.
Attaching the Rail Assembly to
the Rack Cabinet
Follow the procedure below to install the rack-mountable server into a 19-inch rack cabinet.
WARNING
Anchor the equipment rack:
The equipment rack must be anchored to an
unmovable support to prevent it from falling over when one or more servers are
extended in front of it on slide assemblies. The anchors must be able to
withstand a force of up to 113 kg (250 lbs). You must also consider the weight of
any other device installed in the rack.
Main AC power disconnect:
You are responsible for installing an AC power
disconnect for the entire rack unit. This main disconnect must be readily
accessible, and it must be labeled as controlling power to the entire unit, not just
to the server(s).
Grounding the rack installation:
To avoid the potential for an electrical shock
hazard, you must include a third wire safety grounding conductor with the rack
installation. If a server power cord is plugged into an AC outlet that is part of the
rack, then you must provide proper grounding for the rack itself. If server power
cords are plugged into wall AC outlets, the safety grounding conductor in each
power cord provides proper grounding only for the server. You must provide
additional, proper grounding for the rack and other devices installed in it.
Содержание EXPRESS5800/120MF
