![background image](http://html.mh-extra.com/html/nec/express5800-110ei/express5800-110ei_user-manual_251177153.webp)
Installing and Using Utilities 6-5
Express Setup
"Express Setup" is intended for initial setup of the server. Its automatic installation mode guides
the user easily through the process by detailing specific hardware features and providing screen
prompts for software selection and configuration. The program loads the utilities and drivers,
applies RAID settings, partitions the disk, and installs the desired operating system.
If you install Windows Server 2003 or Windows 2000 Server, after a few tasks are completed, all
that remains to be done is to remove the NEC EXPRESSBUILDER CD-ROM and install the
Windows CD-ROM, input a product ID number, and acknowledge the license agreement.
IMPORTANT:
The Express Setup is intended for the initial setup of the server
system and, therefore, the Express Setup clears the contents of the
hard disk.
Once Express setup is started, do not remove "Configuration
Diskette" from the floppy disk drive without any directions.
Tools
"Tools" is also intended for initial setup of the server. It provides more installation options than
Express Setup and permits the user to quickly create utility support disks, run the Off-line
Maintenance Utility and system diagnostic utility, set up a maintenance partition, and update the
various BIOS programs.
NEC Express5800 NEC EXPRESSBUILDER Ver3. xxxx-x Copyright (C) NEC Corporation 2004
Tools Menu
Save/Restore RAID Configuration Data
Off-line Maintenance Utility
System Diagnostics
Create Support Disk
Setup Maintenance Partition
BIOS/FW/etc. Update
RAID Board: Present
Total Drives: 1
Drives in Group: 1
Hot Spares: 1
RAID Level: 7
Write Mode: WRITE_THRU
Maint Part: Present
Help
Return to the Top Menu
Save/Restore RAID Configuration Data
The item allows the configuration information on the disk array system to be saved or
restored from the floppy disk.
–
Save Disk Array Configuration Data
The configuration information on the disk mirroring controller is saved into the floppy
disk. If you set or change RAID, always use this function to save the configuration
information into the floppy disk.
IMPORTANT:
Some Disk Array Controllers do not support this
function. In that case, this menu will not be shown.
Содержание Express5800/110Ei
