Neatech EVO3, Руководство по обслуживанию, Страница: 34 / 93

www.neatech.it
34
2.8.2 Checks to be made on the wheelchair
CHECK PERIOD NOTE
Battery charge level Before each utilize
Check the battery charge level on the indicator
located on the joystick. (see Figure 20)
Electric cables
obstacle
Before each utilize
Check that the wires do not interface with the
movements of the wheelchair.
Tightening of
removable parts
Before each utilize
Ensure all removable parts are securely locked in
place.
Tire pressure Weekly
Verify that the tire pressure is consistent with the
given values:
DRIVE WHEELS: 280 kPa
CASTOR WHEELS: 250 kPA
Overfilling can cause a risk of explosion
Lights check Weekly
Verify that all lights and indicators work properly
and are clean.
This point can apply only if you have lights on
your wheelchair
Cleaning of
wheelchair
Monty
Clean the wheelchair and the upholstery
according to the instructions of this manual
Brake release lever
check
Monty
Check that the brake release is working properly
Tire usury Monty
Check for the tire usury and if necessary contact
your vendor for the replacement
Checking tightness of
chassis screws
Annual
For this operation please contact an authorized
service center
2.8.3 Troubleshooting
EVENT POSSIBLE CAUSE REMEDY
The wheelchair can not
be started
Batteries discharged Charge the batteries
Joystick cable not connected or badly
connected
Properly insert the joystick cable
Main switch is set to OFF
Turn the main switch to ON. If the problem
continues, it means that there are some
electric problems. Please don’t use your
wheelchair and contact an authorized
service center
The wheelchair is turned
on but the chair does not
drive
Batteries in charging
Wait that the batteries are completed
charged
Brake release lever in wrong position
Set properly the brake release lever as it is
shown in section 2.7.3
The wheelchair stops
while driving
Magneto – hydraulic protection switch has
triggered
Turn the main switch to ON. If the problem
continues, it means that there are some
electric problems. Please don’t use your
wheelchair and contact a qualified
technician
Joystick cable not connected or badly
connected
Properly insert the joystick cable
The wheelchair can only
be driven at low speed
Seat lift is too high or anyway the position of
the seat is such that the speed need to be
limited for safety reasons
Adjust the position of the seat
Wheelchair makes noise
Release lever not properly inserted
Insert the release lever correctly as it is
shown in section 2.7.3
Tire puncture
Tire puncture See section 2.8.1
Problems with the seat
system
Broken actuator or software fault Contact an authorized service center