NCR S46, Руководство пользователя

Страница: 24 / 90

Performing a Full Installation
1-14 Installing MP-RAS
CAUTION: Pressing F6 when “Enabled: Manual Configuration” is selected
causes the current PCI device resource assignments to change.
8. For all PCI SCSI devices, highlight “PCI SCSI Device” and press Enter.
–
Change “Enabled: Current Configuration” to “Enabled: Manual
Configuration.”
–
Press F6, and change the IRQ to 11 or 14. Remember to always have
at least one device on IRQ 14.
If network adapters are installed proceed to Step 9. If not, go to Step 10.
9. For all PCI Ethernet adapters, highlight “PCI Ethernet Device” and press
Enter.
–
Change “Enabled: Current Configuration” to “Enabled: Manual
Configuration.”
–
Press F6 and change the IRQ to 9.
10. When all devices have been examined and configured to your satisfaction,
press Esc to return to the SCU main menu. Highlight “Step 4: Save
Configuration” and press Enter. After the changes have been saved,
highlight “Step 6: Exit” and press Enter.
If you choose “Step 6: Exit” without saving your changes, the system
prompts you to save before exiting. You must then back out and choose
“Step 4: Save Configuration.”
11. Create a backup diskette of the System Configuration Utility by selecting
“Create SCU Backup” from the Diagnostic Partition main menu and press
Enter.
12. Create a backup diskette of the BIOS flash utility by selecting “BIOS
Flash Utilities” from the Diagnostic Partition main menu and then select
“Create Flash Backup.”
Note: These diskettes are to be used only for backup purposes. You are not
authorized to copy program files, nor to use these diskettes on any other
system.