Nautel NX400, Руководство по установке

Страница: 71 / 89

NX400 Installation Manual Commissioning tasks
Page 10-8 Issue 1.0 2017-06-30
Network Setup
If you wish to remotely control the transmitter via a network or directly through a laptop, configure
your network parameters as follows:
1. Verify that the networking (DHCP enable or disable) decisions outlined in Section 2
“Preparing for installation” on page 2-1 of the Pre-Installation Manual have been made. To
use DHCP, you must have a visible DHCP server on your network. If you are not planning
to use DHCP (i.e., your network does not have a DHCP server), you must obtain an IP
address and netmask from your network administrator as well as gateway and nameserver(s)
as applicable.
2. From the AUI, navigate to the
Menu
->
User Settings
->
Network Settings
screen.
3. Ensure your network or laptop is connected to the
LAN1
connector on the SBC (see
Figure 9.5 on page 9-6 ). Use one of the following two methods, depending on whether
you are automatically (DHCP) or manually (static) assigning an IP address:
– If your network has a DHCP server and DHCP is set to ENABLE (factory default), IP
addresses will be automatically assigned. Verify this has occurred by viewing the IP
Address and Netmask address sub-menus (Gateway and Nameserver addresses are
optional; view as applicable). The MAC Address field cannot be modified.
– If your network does not have a DHCP server or you wish to assign static IP addresses
(i.e., direct connection with a laptop), set DHCP to DISABLE. Enter the appropriate
addresses in the IP Address, Netmask, Gateway and Nameserver sub-menus, as
applicable.
4. Once you have established an IP address, you can login to the NX400’s advanced user
interface (AUI), which allows you to remotely control and monitor the NX400. See the
“Operating the transmitter” section of the Operations and Maintenance Manual for detailed
AUI information.