Nautel NX400, Руководство по установке

Страница: 24 / 89

NX400 Installation Manual Completing cabinet assembly
Page 3-2 Issue 1.0 2017-06-30
Figure 3.1: Cabinet Leveler Detail
6. Open the filter door behind each cabinet’s front door by unlocking the door (refer to the
Operations & Maintenance Manual for key sequence instructions and gaining access to
locked areas of the transmitter) and removing its M5 screws. Retain hardware.
7. See Figure 3.2 on page 3-3 and Figure 3.5 on page 3-11 . Obtain six “Long Vertical Channel
Joiners” (Nautel Part # 207-8270), three “Horizontal Channel Joiner” (Nautel Part #
207-8270-01) and six “Short Vertical Channel Joiners” (Nautel Part # 207-8270-02), which
are bubble-wrapped and secured inside the filter compartment of cabinets 1 and 2.
8. Install the joiners between cabinet 1 and cabinet 2, between cabinet 2 and cabinet 3, and
between cabinet 3 and cabinet 4. Install the short joiners from the back of the cabinets,
taking care not to damage the upper and lower teflon support plates. Install the vertical and
horizontal joiners from the inside of the filter compartment. Secure each joiner using M6
hardware - starting at one end and moving toward the other end while making sure the joiner
is properly seated).
Note:
It may be necessary to move the individual cabinets slightly to allow cabinet joiner installation. Any
hardware dropped into the cabinets during installation must be located and removed.
CABINET
LEVELER
(located in each
corner of each
cabinet)