Nautel GV3.5, Руководство по эксплуатации и техническому обслуживанию, Страница: 198 / 251

GV5/GV3.5 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 0.2 2014-07-23 PAGE 3.2.181
Digital Outputs - Controller UI
Using the
Remote Outputs
screens (see Figure 3.2.154 on page 3.2.180 ), you can configure up to 16
digital outputs that indicate either the presence of various alarms or the status of operator controlled
circuits.
Nautel sets digital output defaults prior to shipping. See the GV5/GV3.5 Pre-installation Manual for
details.
Figure 3.2.155: Remote Outputs Screens (Output 1 shown)
Use the up and down buttons to select the desired digital output (1 through 16) from the list. Each
screen shows the current digital output parameter (e.g., RF On/Off), as well as the polarity (e.g., RF
On = Low) and current state (e.g., high, low) of the corresponding output pin. Use the right-arrow
button to enter the
Selection/Polarity screen for the selected output to allow editing of the selection
or the polarity. Press cancel ( X ) to return to the previous menu.
If you save a change to a digital output via the controller UI, it will also be displayed on the AUI page.
NOTE
: The selection and polarity options for digital outputs are the same as described in Select Output
Channel - AUI, on page 3.2.177 and Configure Output Logic - AUI, on page 3.2.178 .