Nautel GV3.5, Руководство по эксплуатации и техническому обслуживанию, Страница: 131 / 251

GV5/GV3.5 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.114 VERSION 0.2 2014-07-23
Resetting the Single-Board Computer (SBC)
NOTE
: An SBC reset is available using the controller UI. It can also be performed from the AUI, using the
Reboot AUI
button on the
Reset
page (see Reset, on page 3.2.102 ). Once the SBC is reset, all users that
were remotely connected (logged in) will be logged out.
From the controller UI, you can reset the SBC. To view the
SBC Reset
screen, select
System Settings ->
SBC Reset
from the
Main Menu
(see Figure 3.2.95 ).
Figure 3.2.95: SBC Reset Screen
Use the up and down buttons to toggle between Force SBC Reset and Cancel . Press the accept
(checkmark) button to save the change. If a reset is selected, it will occur immediately. Select Cancel or
press X to abort the reset and return to the previous menu.
Configuring SBC Watchdog
NOTE
: SBC watchdog configuration is only available using the controller UI.
From the controller UI, you can enable or disable the SBC watchdog feature. This feature, when
enabled, monitors communication between the SBC and the DSP processor on the exciter/control PWB
within the controller module. If communication is lost for more than 30 seconds, the transmitter will
initiate an alarm and reboot the SBC. To view the
SBC Watchdog screen, select System Settings ->
SBC Watchdog from the Main Menu (see Figure 3.2.96 ).
Figure 3.2.96: SBC Watchdog Screen
Use the up and down buttons to toggle between
ON
(enabled) and
OFF
(disabled)
.
Press the accept
(checkmark) button to save the change. Press cancel (
X
) to discard changes and return to the previous
menu.