Index
I-4
www.ni.com
programming video parameters. See video
parameters, programming.
PXI-1408 device. See also PCI/PXI-1408
devices.
pins used (table), 1-2
using with CompactPCI, 1-2
R
RAM, nonvolatile (NVRAM), 3-5
referenced single-ended (RSE) input mode.
See RSE (referenced single-ended) input
mode.
region of interest
control circuitry, 3-4
programming video parameters, 3-8
RSE (referenced single-ended) input mode
external CLK and synchronization input
mode, 2-7
VIDEO0 input, 2-6 to 2-7
RTSI bus, 3-4
S
S1 switch, 2-8
scaling-down circuitry, 3-8
scatter-gather DMA controllers, 3-4
signal connections, 4-1 to 4-3
BNC connector, 4-1
external connection specifications, A-2
I/O connector, 4-1 to 4-3
pin assignments (figure), 4-2
signal descriptions (table), 4-2 to 4-3
software control of video acquisition, 3-5
software programming choices, 1-3 to 1-6
National Instruments IMAQ Vision, 1-5
National Instruments IMAQ Vision
Builder, 1-5
NI-IMAQ driver software, 1-4
specifications, A-1 to A-4
A/D conversion, A-2
environment, A-4
external connections, A-2
formats supported, A-1
internal pixel clock, A-3
PCI interface, A-3
physical, A-4
power requirements, A-3
video input, A-1
standard acquisition mode, 3-9
start conditions, video acquisition, 3-5
Switch S1, 2-8
synchronization circuitry, 3-3
synchronization input mode, 2-7
system requirements, 2-1 to 2-2
T
technical support resources, C-1 to C-2
TRIG<3..0> signal (table), 4-3
trigger control
trigger control and mapping circuitry, 3-4
video acquisition, 3-5
V
VCO and PLL circuitry, 3-3
vertical synchronization. See VSYNC.
video acquisition, 3-5 to 3-8
acquisition window control, 3-6 to 3-7
programming video parameters,
3-7 to 3-8
start conditions, 3-5
video input specifications, A-1
video line, 3-6
video mux, 3-2
