National Flooring Equipment 5700-aus, Инструкция по эксплуатации

Страница: 21 / 58

Machine Operation
WORKING OVER WOOD
A heavy machine cannot be used on wood sub fl oors or raised panel computer fl oors.
Keep machine light, remove all weights. A weighted machine could break through the
fl oor. The slide plate should be adjusted to a low setting 2.5 cm (1”) off the fl oor. Blades
should be as fl at of an angle as possible. Use a “shoe blade”, Extra Heavy Duty Blade
(these blades have a bend to them) or a regular blade, bevel up. When using a regular
blade, bending up the corners of the blade will help from the blade digging into the
fl oor.
Sometimes a shank blade or a shank blade with a carbide tip will work. Allow blade to
shear material from the
fl oor. The trick on wood fl oors is to run the blade fl at. Approach
should be at a 45° angle to the board. This keeps from digging into the board and hang-
ing up at the seams.
WORKING OVER SOFT SUB-FLOOR
The slide plate should be adjusted to a low setting 2.5 cm (1”) off the fl oor. Blades should
be as fl at of an angle as possible. Use a “shoe blade”, Extra Heavy Duty Blade (these
blades have a bend to them) or a regular blade, bevel up. When using a regular blade,
bending up the corners of the blade will help from the blade digging into the
fl oor. Some-
times a shank blade or a shank blade with a carbide tip will work.
Fax: 763-535-8255 info@nationalequipment.com 21
CAUTION:
BLADES ARE SHARP; USE EXTREME CAUTION WHEN HANDLING.
CAUTION:
NEVER CHANGE CUTTING HEAD OR SERVICE BLADES WHILE
MACHINE IS RUNNING.
WARNING:
DISARM MACHINE WHEN IT IS NOT IN USE. REMOVE THE
CUTTING HEAD OR DROP CUTTING HEAD TO THE FLOOR. FAILURE TO DO SO
COULD CAUSE BODILY INJURY.