Battery/Charger Information
www.nationalequipment.com
Phone: 763-315-5300
9
CHARGER INSTRUCTIONS
Check that the temporary label on top of the charger marked with the pro
fi
le setting
matches your battery type.
These chargers work very simply. Once connected and plugged into AC power, the LED
will
fl
ash red for a few seconds, then turn steady red. When the cycle is 80% complete it
will turn yellow, and
fi
nally green when cycle is complete.
If the pro
fi
le is set to maintain the battery(s), the LED will
fl
icker green. If the pro
fi
le is set
to shut off, the cycle will end with a steady green. The LED may also
fl
icker when it is at
the high limit of the charge cycle.
Look to the trouble shooting section for any deviations from this.
Before making AC connections, refer to the requirements on the charger ID label.
To reduce the risk of
fi
re, use this charger only on branch circuits that are protected by a
circuit breaker or fuse, and that are adequate to carry the power drawn by the charger.
This battery charger must be grounded to reduce the risk of electric shock. 230/240 volt
chargers are equipped with a grounding type plug..
If an extension cord must be used, make sure it is in good condition. Use a three conduc-
tor cord no smaller than the size being used on the charger, and keep it as short as
possible. The use of an improper extension cord could result in a risk of a
fi
re or electric
shock. Locate all cords so that they will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
Do not use charger if it shows signs of physical stress, or if DC output leads or connector
feel hot when used.
Do not disconnect the DC output clamps, or connector from the batteries when the char-
ger is on. The resulting arcing could cause the batteries to explode.
Failure to unplug AC power before moving or driving equipment will result in damage to
cords, plugs and receptacles.
Do not over discharge batteries. Excessive discharge can cause polarity reversal of indi-
vidual cells resulting in complete battery failure. Re-charge batteries as soon as possible
after a deep discharge, but not if they are warm, allow a cooling down period.
Caution:
The charger is
not
water proof they are water resistant. They cannot withstand
immersion, continuous exposure (such as pressure washers or hoses) or heavy rain.
Machine contains a drive lockout option which will disable the drive mechanism of the
equipment while the charger is plugged in. This will prevent damage to the AC cord or
receptale.
WARNING:
DISCONNECT FROM POWER SOURCE BEFORE OPERATING.
FAILURE TO DO SO COULD CAUSE DAMAGE TO MACHINE OR BODILY INJURY.
FIG. A
WARNING:
ELECTRICAL SHOCK HAZARD. ONLY USE NATIONAL’S AP-
PROVED CHARGING SYSTEM.
Содержание 5700-aus
Страница 1: ...Read Manual Before Operating Machine ALL DAY BATTERY RIDE ON SCRAPER INSTRUCTION MANUAL Rev B 401810...
Страница 2: ......
Страница 44: ...Parts List and Diagrams Fax 763 535 8255 info nationalequipment com 44 5700 BATTERY WIRING...
Страница 46: ...Parts List and Diagrams Fax 763 535 8255 info nationalequipment com 46 5700 MACHINE WIRING...