NARGESA C3006, Инструкция

Страница: 15 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 14
Picture 10. Information of the top memory 0
Apart from the information indicated in the previous picture in the upper picture of the LCD display it could
be seen the performance way of the shears, intermitently intercalated with the memory of the current top.
Such a mode allows to make cutting operations with the shears in both, the automatic mode and the
manual mode. So, depending on the performance mode currently selected, it will be seen on the screen a
label of Picture 11 or that of Picture 12, intercalated with the one on Picture 10
Picture 11. Information of the Shears in manual mode.
Picture 12. Information of the Shears in automatic mode.
In case the machine hasn’t been completely fed then it will show directly in the LCD display all information
shown in Picture 10, since in this case it is not necessary that the top goes back to the starting point again
on default. Likewise it will be possible to see the current top position of the machine on the 7-fragments
display.
5.5. Surfing throught the top memories
There are 10 preset memories of the top, all of them with the counter to 0 and the position of the top
gradually increased regularly in gaps of 10mm.
To go through the different memories, it is necessary to press the Navigation keys, silkscreen printed with:
To the pressure of each of these keys there will appear on screen the information according to the current
memory of the top.
M00 CONT:0000
TOP = 100.0 mm
MANUAL
TOP = 100.0 mm
AUTOMATIC
TOP = 100.0 mm