NARGESA C3006, Инструкция

Страница: 16 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 15
To find the desired memory faster, keep the Navigations keys preddes for more than 1.5 sec. Keeping the
key pressed it will pass to the next memory every 0.25 sec.
An example of a top memory could be the one below:
Picture 13. Information of the memory of the top 6.
5.6. Positioning the top
Press the Return key at the sight of Picture 13 for the top to be located in the indicated figure every (70.0
mm)
Once this has been accried out the top will beging it positioning until it reaches the specified figure. We can
see the position of it in the 7-fragments display as it is moving. Like this we get to know in real time the
location of the top in our shears.
Therefore we can select the desired memory of the top amog the 16 possible ones and once it is displayed
on screen, press the return to confirm the top at which it must be set in the figure shown on the screen.
5.6.1. Introducing the desired figure
Despite the 10 preset memories of the top, it is quite probable to require intercalated which are not
reflected on these memories.
In order to enter the desired figure just insert the new value for the top positioning by using the number
keyboard. Once this value has been inserted, confirm it by pressing the return key, placing the top in the
new inserted position.
Let’s see an example of the steps to follow, with the new inserted figure of 443.2 mm:
Picture 14. Information of thetop of the memory 0
At pressing the first number ( 5 in our sample), the message on the screen changes into this other one:
Picture 15. Inserting a new figure
M6 CONT: 0000
TOP = 70.0 mm
M00 CONT: 0000
TOP = 10.0 mm
M00 CONT: 0000
“”””””””” 5.0 mm