NARGESA C3006, Инструкция

Страница: 18 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 17
Right now the top will activate moving towards the specified position, what can be seen by taking a look at
the 7 fragments display. When the top reaches the desired figure it stops, and it is reflected in the seven
fragments displays.
Now that the top is in the new position, the information shown in the display is the one below:
Picture 21. Information of the memory of the top 0
Picture 22. Information of the guillotine in manual mode.
5.6.2. Cancelling the introduction of a figure
In case we have gone wrong while inserting thr new figure we can cancel the operation pressing the ESC
key
Picture 23. Inserting the new figure.
When we do that the memory of the current top shows up on screen again, with the value thet it had before
the modification we were going to make.
Picture 24. Information of the memory of the top 0
M00 CONT: 0000
TOP = 443.2 mm
MANUAL
TOP = 443.2 mm
MANUAL
TOP = 443.2 mm
M00 CONT: 0000
TOP = 10.0 mm