NARGESA C3006, Инструкция

Страница: 17 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 16
Now we insert the second number followed by the third one, shown in this screen:
Picture 16. Inserting the new figure.
Picture 17. Inserting the new figure.
Next we press the key according to the Decimal Point, what enables us to see on the screen what follows:
Picture 18. Inserting a new figure
Finally, we insert the final number (2, in this example),getting a new figure as it can be seen in Picture 19:
Picture 19. Inserting a new figure
Once these simple steps are carried out, we press the Return Key to confirm the value that has been
inserted. Then unless the new inserted figures is not higher than the total length of the top, it could be seen
on the LCD displays the information reflected in the following picture:
Picture 20. Inserting a new figure
M00 CONT: 0000
“””””””””””” 43 mm
M00 CONT: 0000
“””””””””””” 443 mm
M00 CONT: 0000
“””””””””””” 443 mm
M00 CONT: 0000
“””””””””” 443.2 mm
POSITIONING
TOP = 443.2 mm