NARGESA C3006, Инструкция

Страница: 32 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 31
When the error message dissapears the menu for the selection of the block to work with will show up
again.
5.11.2. Operating with one block
When working with a given block, the Guillotine C3006 gets the top in the position according to the value in
the first cell of this block. During this process the positioning message will show up on the LCD screen.
Picture 63. Positioning of the top
It is to bear in mind that the posotion value appearing in the lower row will change in each case depending
on the on the position that the top is going to be set.
Once the top has been set, it will appear the information regarding the first cell of the block that has been
operating with. There is an example in the following picture:
Picture 64. Information regarding the working block and cell.
As you can see, there are the block and cell operating with in the upper row, indicated in the lower part of
the LCD display, the cuts meter of the block and the position of the top in the current cell. The block
performance mode, (Manual or Automatic) shows up intermittently in the upper part of the LCD display.
Picture 65. Detail of the performance mode of the working block.
At this moment what’s left is just to make the cut, the performance mode from which it will change
according to the defined performance mode (Manual or Automatic).
Something to keep in mind is that, apart from the performance mode, (Manual or Automatic), the
positioning of the top in the figure indicated by the next cell will be performed whenever the blade finishes
the descent movement. Without making the ascent movement. This one will only go up when the top has
reached the correct working position.
When the Guillotine C3006 reaches the cutting lower position (after making the descent movement
according to the last cut made), the acoustic pilot activates in order to indicate the end of the block. At this
moment the cuts meter also increases and the top goes to the first block cell again.
POSITIONING THE
TOP = 500.0 mm
BLOCK 00 CELL 00
CNT = 0000 500.0 mm
AUTOMATIC
CNT = 0000 500.0 mm