NARGESA C3006, Инструкция

Страница: 20 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 19
5.7.1. Manual mode
If your choice is to make the cutting operations with the shears in Manual mode, then proceed by following
the information indicated in the following pictures:
Picture 28. Information of the memory of the top. 1
Picture 29. Information of the shears in manual mode.
Once the cutting sheet is introduced, press the pedal for the blade to go down In the manual mode, the
blade goes down while you keep the pedal pressed down, in such a way that if you loose it, then the blade
changes its movement the other way around and starts going up until it reaches the upper rest position.
Then once we get to know this performance principle, if a sheet need to be cut, the user has to press the
pedal until the blade reaches the lower position of its vertical route. Once it is there and therefore it has cut
the sheet, it won’t go up again until you stop pressing the pedal. If you do it the shears blade will start
moving until it reaches the upper rest position.
You have to know also that if you press the pedal while the blade is going up, the blade will invert its
movement and will go down again.
On the other hand and as a remarkable point, you must be conscious that every time you press the pedal
to make one cutting operation, it will automatically increase the cutting meters associated to the memory of
the top that is performing. This will show in the following picture:
Picture 30. The memory meter of top 1 has been increased
Therefore, if the pedal is pressed several times to make a cutting operation, the couter meter will increase
the same number twice, since te machine will take for granted that you have made all those cuts. This kind
of performance is based in the need to count all the times the pedal has been pressed, because several
times the machine’s rented to other people and the rental price depends on the number of cuts made. So
the operative will make a reasonable use of it, since the more times he presses the pedal to make the
same number of cuts of sheet, the more expensive the rental will be.
M01 CONT: 0000
TOP = 330.0 mm
M00 CONT: 0000
TOP = 330.0 mm
M00 CONT: 0000
TOP = 330.0 mm