NARGESA C3006, Инструкция

Страница: 14 / 71

C3006 HYDRAULIC SHEAR INSTRUCTIONS BOOK 13
5.3. Feeding of the guillotine
In order to power on the machine, it is enough jus by set the Go switch in the position o Connected. Then it
will show up al abel on screen as the one below:
Picture 8. Message of activation of the machine
The 7 fragments displays are checked automatically showing a sequence of numbers in regression. Once
this routine revision has been carried out all 7 fragment displays will turn off and will deactivate LCD display
light at the same time, however the same label of Picture 8 will seen .
Right now the machine is in a StandBy mode, it happens when it is activated but in rest position awaiting
any command the user orders.
5.4. Activation of the machine
With the machine already started and in StandBy, it could be activated to work with the steps detailed
below.
Press the key ON to proceed properly. Once you do it you will see a label like the one below and just in
case you finish giving power to the machine as it was described in the section below you will see in the
LCD display an initialization label as the one below
Picture 9. C3006 initialization label
At the same time it will be seen intermitently in the 7-fragments displays the total length of the top while this
is moved at a moderate speed, getting apart from the shears blade in order to be located in the highest
working figure.en la cota Once this top is located in the indicated positions, then the intermitence of the 7-
fragments displays will disappear and these ones will show the value of the top route length.
Likewise, there will be a label in the screen showing the following message which will show the in the
memory of the current top the cutting meter associated to this memory and the position of the top
corresponding to the visualized memory.
NARGESA
C3006
NARGESA
C3006