2 Preparing the SMARTS II for use
16
SMARTS II
!
Do not solder anything to batteries.
Use and replacement of batteries
Improper replacement of batteries may result in injury and damage to
the device or the batteries.
!
Only operate the device with the permitted batteries (see
1.2 About this monitor or refer to the datasheet for
information on the permissible types).
!
Never short-circuit the contacts of the batteries, i.e. never
touch both terminals with metal parts at the same time.
!
Observe the polarity of the snap connector and insert the
batteries accordingly.
!
Always close the battery compartment immediately after
replacement, and never operate the device with the battery
compartment open.
Combustion of the batteries
Through an incorrect use it is possible that the batteries could ignite.
This can cause injuries and damage to the batteries.
!
To prevent the batteries from igniting, do not expose the
batteries to high temperatures for long periods of time.
!
If the anode or cathode of the batteries comes into contact
with another metal, heat may develop and the electrolyte
may leak. The electrolyte is flammable. If the electrolyte has
leaked, the batteries must be immediately removed from the
vicinity of a fire.
!
If batteries burn, irritation may occur in the eyes, skin and
respiratory tract as a result of developing smoke or vapors
(see next section).
Dangerous emitted substances
Under normal handling conditions, no dangerous substances will escape
from the batteries, and thus no contact with toxic substances can occur.
The only danger of leakage is from mechanical damage to the housing.
If chemicals should escape, the following must be observed:
!
Emitted gases (from fire or mechanical damage) can cause
respiratory problems. In case of an emergency, see a doctor
immediately.
!
Skin irritation may occur if the skin comes into contact with
chemicals. Wash the skin thoroughly with soap and water.
!
Irritation of the eyes may occur. Immediately wash the eyes
thoroughly with water and seek medical attention.
Содержание L3HARRIS SMARTS II
Страница 1: ...SMARTS II Ultra Wideband RF Radiation Area Monitor Operating Manual...
Страница 36: ...36 SMARTS II 7 3 Outline drawing...
Страница 37: ...7 Specifications SMARTS II 37 7 4 Declaration of conformity...
Страница 38: ...38 SMARTS II 7 5 Declaration of origin Country of Origin Germany...