Napoleon TQ285X, Инструкция по эксплуатации

Страница: 13 / 148

www.napoleongrills.com
13
EN
Troubleshooting
Problem Possible Causes Solution
Low heat / Low flame
when valve turned to
high.
Blockage of gas.
Improper preheating.
Check for spider webs in the burner or orifice.
Preheat grill with main burners on high for 5
to 10 minutes.
Excessive flare-ups/
uneven heat.
Improper preheating.
Excessive grease and ash build up in
drip pan.
Preheat grill with both main burners on high
for 5 to 10 minutes.
Clean drip pan regularly. Do not line pan with
aluminum foil. Refer to cleaning instructions.
Burners burn with yellow
flame, accompanied by
the smell of gas.
Possible spider web or other debris, or
improper air shutter adjustment.
Thoroughly clean burner by removing. See
general maintenance instructions. Open air
shutter slightly according to combustion air
adjustment instructions. (This must be done
by a qualified gas installer.)
Flames lift away from
burner, accompanied
by the smell of gas, and
possibly difficulties in
lighting.
Improper air shutter adjustment. Close air shutter slightly according to
combustion air adjustment instructions. (This
must be done by a qualified gas installer.)
Burner will not light with
the igniter, but will light
with a match.
Jet-fire outlet is dirty or clogged. Clean jet-fire outlet with a soft bristle brush.
Humming regulator. Normal occurrence on hot days. This is not a defect. It is caused by internal
vibrations in the regulator and does not affect
the performance or safety of the gas grill.
Humming regulators will not be replaced.
“Paint” appears to be
peeling inside lid or hood.
Grease build-up on inside surfaces. This is not a defect. The peeling is caused by
hardened grease, which dries into paint-like
shards that flake off. Regular cleaning will
prevent this. See cleaning instructions.
Burner output on “high”
setting is too low.
(Rumbling noise and
fluttering blue flame at
burner surface.)
Lack of gas.
Supply hose is pinched.
Dirty or clogged orifice.
Spider webs or other matter in venturi
tube.
Check gas level in propane cylinder.
Reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.