NAPCO RPXP6GT, Руководство по установке

Страница: 22 / 28

22
WI1372 XP-600 Installation Instructions
The Computer is now in STANDBY
Site
At the site perform the following three steps:
•
Arm the panel.
•
Disarm the panel.
•
Enter
A 6
. The panel will now call
the download computer running
PCPreset. PCPreset will answer the
call, establish a connection, and then
download the account that matches the
Auto Download ID Number [93] with the
account of the same number in the list
that PCPreset is currently running.
Dealer Programming
[94]Dealer Code
The default Dealer Code is
4567
. Program
a new 4-digit Dealer Code. When the panel
is defaulted, the Dealer Code will be
changed back to the default Dealer Code of
4567
only if Dealer Code Lockout [96-1]
has not been programmed.
[95]User 1 Code
The 1st User code is a program code as
well as an Arm/Disarm code. The default
User Code is
1234
. If User 1 Code Lockout
is programmed the User 1 Code cannot be
programmed from User Program Mode.
[96]Dealer Options 1
(1) Dealer Code Lockout - Program to
prevent the Dealer Code from changing with
a panel default.
(2) User 1 Code Lockout - If programmed
the User 1 Code cannot be programmed
from User Program Mode.
(3) Household Fire - Activates the following
UL required features:
There is a 4 hour re-sound of wireless
Smoke Low Battery and wireless Smoke
Supervisory system troubles.
•
An active System Battery test performed
every 4 hours instead of 24 hours and
Wireless Smoke Supervisory Timer is
set to 4 hours.
•
Fire Bell Timing is March Time.
•
Wireless Smoke Supervisory Time is
fixed at 4 hours.
(4) Fire Trouble on Fire LED - Normally all
troubles are displayed on the
H
SYSTEM
TROUBLE LED, including Fire Trouble. If
required Fire Trouble can be displayed on
the Fire
I
LED. Fire Trouble is indicated
by a steady Fire LED.
[97]Dealer Options 2
(1) International Dialing Protocol - No
dialing if no dial tone, 60 s between attempts
and 4 s wait for dial tone.
(2) Invert Bell Output - Inverts the Bell
polarity and removes supervision from the
bell circuit.
(3) System Trouble Auto Restore -
Normally, System troubles require
acknowledgment (View System Trouble) in
order to restore. If this option is selected
troubles will restore without requiring
acknowledgment.
(4) User 1 Code-Program only - If enabled
User 1 Code will function only as the User
Program Code and will not Arm/Disarm the
panel.
Note: All programming within Programming
Blocks [96] & [97] will not change if the
panel is defaulted.
[98] Number of Re-Dials
The Number of re-dial attempts made by the
panel before indicating a
Fail-to-Communicate
(System Trouble 1-3).