16
WI1372 XP-600 Installation Instructions
then press the
i
key to blank the last
digit.
[31]Telephone Number 1
Program the phone number to be dialed for
Telephone Number 1. Program the number
directly, just as it is entered on a TouchTone
phone. A fixed
Dial Tone Detection (E) is
included prior to the
Dialing Prefix
(Block
Number 44)
.
Programming an E is not
required for
Telco 1, Telco 2 and Telco 3. If
dial tone detection is not desired select
No
Dial Tone Detection
in Communicator
Features [46-1]. Use the
i
key to blank
out remaining digits in the phone number.
[32]Receiver Format
Select the receiver format to be used to
report for Telephone Number 1: Program a
0 to disable reporting to Telco 1.
[0] Disabled [4] Universal High Speed
[1] Ademco Slow [5] Reserved
[2] Radionics Slow [6] Point ID
[3] Silent Knight Fast [7] Pager
[33]Receiver Options
(1) 2300 Hz HS/Kissoff
- Select 2300 Hz
Handshake and Kissoff.
(2) Sumcheck
- Only used for the following
Receiver Formats: Ademco Slow, Radionics
Fast, Silent Knight Fast and Universal High
Speed. This is a sophisticated data format
used to enhance the speed and check the
accuracy of the received transmission. This
format should be used whenever the central
station has this capability. Instead of
sending a second round to verify correct
data, the panel sends a Sumcheck digit after
sending the Subscriber ID and Alarm Code.
(3) Single Digit
- 3/1 Format. 3-digit
Subscriber ID number and a 1-digit Alarm
Code will be transmitted.
(4) No Handshake
- (All receiver formats
except Pager Format). If programmed no
Handshake/Kissoff is required by the panel.
[34]Zone Report, Telco 1
Select zone(s) required to send an alarm
report to Telephone Number 1.
[35]Zone Restore Report, Telco 1
Select zone(s) required to send a restore
report to Telephone Number 1. The zones
will send a restore after Bell time-out, unless
programmed as silent zones.
[36]System Reporting, Telco 1
(1) Keypad Fire
- Program to activate a
Keypad Fire report (
ee
).
(2) AUX/AMBUSH
- Program to activate an
AUX or AMBUSH report (
ff
).
(3) Panic
- Program to activate a Panic
report (
gG
).
(4) Test Timer
- Program to activate a Test
Timer report.
[37]System Reporting, Telco 1
(1)
Y
AC Fail Report
- Program to activate
an AC Fail report (15 minute fixed report delay).
(2) Low Battery
Report -
Program to
activate a Low Battery report.
(3) *Trouble Report
- Program to activate a
Trouble report.
(4)
I
Fire
Report
- Program to activate a
Fire report.
*
Includes Bell Cut, Fire Trouble, Receiver
Fail-to-Respond, Receiver Tamper,
Receiver JAM, Wireless Smoke Low
Battery, Wireless Smoke Supervisory Fail.
Point ID format will report trouble(s) by
device and ID number.
[38]System Restore Report, Telco 1
(1) AC Restore
- Program to activate an AC
Restore report.
(2) Battery Restore
- Program to activate a
