10
WI1372 XP-600 Installation Instructions
To change the User 1 Code from its default
value of 1234, program the 4-digit User 1 Code
through Dealer Programming [95]. User 1 Arm/
Disarm code is also used to program User
Codes 2 - 6. By default, the User 1 code cannot
be re-programmed by the user.
If it is necessary to change the User 1 code, it
can be changed through downloading or Dealer
keypad programming. From Dealer Program
Mode, change the U
ser 1 Code Lockout
([96-2]
LED=OFF) to disabled.
Entering User Program Mode
1. Enter
A
8
2. Enter User 1 Code
(
1 2 3 4
)
(Default)
While in User Program Mode the Armed,
READY and
H
SYSTEM Trouble LEDs will
continue to flash, follow the example below to
program
User 2’s
code to
1923.
User Mode Programming Example:
1.Press
2
, Zone 2 LED will Flash
2.Enter
1
9
2
3
, Zone 2 LED will
continue to flash until the 4th digit is
entered. The keypad will beep 4 times
confirming a valid entry (Zone LED steady).
Deleting a User Code
Press the number of the User to be deleted, the
zone LED will be flashing indicating that the user
has been selected. Press
A
4
, the LED
associated with the user will now be OFF.
Exiting User Program Mode
To exit User Program Mode press the
b
key.
XP-600 Commands
User Commands
A
1
Bell Test
Enter this command to turn on the Bell, keypad
sounder and keypad LEDs for 2 seconds. The
battery is tested during a Bell Test, and
automatically every *24 hours to ensure proper
battery operation under load. The Alarm output
requires a battery in order to supply the
specified output. If the battery cannot sustain
the load, a low battery indication will be
displayed. A battery test is also performed on
power-up after a 3 minute delay.
*A battery test occurs every 4 hours when
Household Fire
[96-3] has been selected.
CC
Group Bypass
Enter this command to bypass all
Exit/Entry
Follower Zones
or
Home/Away Zones
(only if
the system is programmed exclusively for
Home/Away with Delay zones).
A
4
Instant
Enter this command before or after arming to
remove the entry delay on
Entry/Exit Zones
.
The keypad ARMED LED will flicker rapidly.
Faulting a
Exit/Entry Zone
will result in an
immediate alarm.
A
5
Chime ON/OFF
Enter this command to turn chime ON/OFF.
The Keypad will chime on any zone that has not
been selected as an
Exit/Entry Follower Zone
,
Home/Away with Delay Zones,
or
24 Hour Zone
.
Zone LED Meaning
OFF
User Arm/Disarm Code not programmed
Flashing
User Arm/Code is currently being programmed
Steady
User Arm/Disarm Code has been programmed
TABLE
5
Z
ONE
L
ED
D
EFINITION
-U
SER
P
ROGRAM
M
ODE
