15
USERS (Continued)
; 6 :
6. Enable Total User Lockout Mode
(This Function enabled through keypad only)
7. Disable Total User Lockout Mode
(This Function enabled through keypad only)
; 7 :
User Lockout Mode
Prevents all User Codes (Except User 1 Code) from operating the lock.
Note:
No other programming
functions or schedules (including a DL-Windows data transfer) will re-enable Users. Users must be re-
enabled with Function 7.
Note:
Does not change the User enable/disable status.
Note:
If the lock
is currently in Passage Mode (door "unlocked") and Function 6 is programmed, the lock will remain in
Passage Mode.
M
Service Code is a One-Time-Only Code. Once it is used, it is disabled until enabled again.
NOTE:
User Number 297 is used to reset Service Code Use. See "Terminology Used in
this Manual" on page 6 for more information and examples regarding special Users 297-300.
; 9 :
9. Enable User 300
(Service Code)
; 1 0 ; 0 0 0 :
10. Erase All Users Except the Master Code
(User 1)
(This Function enabled through keypad only)
Erases all User Codes except the Master Code (User 1).
Function 10 can only be performed using the keypad.
M
11. Reserved
3. Disable User
; 3 ;
[ _ _ _ _ ]
:
(User Number)
4. Enable User
; 4 ;
[ _ _ _ _ ]
:
(User Number)
User Enable/Disable
(By User Number)
User Number must be between 2 and 5000.
NOTE:
Will Enable/Disable Users even if the User is associated with an enabled Group. Use Function 3 to disable a specific User
Number and their associated User Code. If the disabled User Code is entered, the lock will flash 1 Green and 4 Red Flashes (with
1 long and 5 short beeps) indicating that the User Code exists in memory, but is disabled. Function 4 will "undo" Function 3.
2
"Keypad Programming" Functions (cont'd)
Allows Program Mode exit for keypads without hold-down functionality, such as some Wiegand readers with integral keypads.
3
; 8 :
8. Exit Program Mode
5. Reserved
2
