NAPCO Gemini GEM-P816, Инструкция по программированию

Страница: 38 / 56

GEM-P816 Programming Instructions
Page 38
NAPCO Security Systems
R
ACCESSING USER PROGRAM MODE
1. Press
EEEEEE
R
2. Press
Q
Until "
ACTIVATE PROGRAM Y/N
" appears on LCD screen.
3. Press
P
To Enter User Program Mode
4. Press
C
To Exit User Program Mode when finished
New Panel (Default User Code = 123)
Existing Panel (Any Code with User Program Option Enabled)
USER CODES
Up to 16 User Codes may be programmed.
NOTE: In this mode, only the code is pro-
grammable; the accompanying Area Options
must be programmed in the Dealer Program
Mode (see page 5).
Use the
R
button to place the cursor
over the User Number.
Enter a User Number (01–16) using the
number buttons. The cursor will then
advance to the User Code and read the
existing code, if any.
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press
G 0
button.
Press the
U
button to save the code in memory.
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT/YES button or the
PRIOR/NO button.
GEM-K1CAe2 Keypad (Direct Entry)
Enter user code
U01 123 - 9-
Programming User Codes with GEM-K1CA Keypad
To Program User Codes
1. Set Cursor Position using the
R
button.
2. Enter 2-digit User Number (01-
16) directly using number but-
tons (0-9).
3. Enter Code (1-6 digits) directly
using number buttons (0-9).
4. Press the
U
button to save
each code.
NOTE: Press
G 0
button to clear character at cursor.
To continue press
P
or
Q
button.
G E M I N I
E n t e r u s e r c o d e
U 0 1 1 2 3 - -
ARM
ED
COMPUTER IZED SE CU RITY SYS TE M
STA
TUS
R 1 2 3
B 4 5 6
C 7 8 9 0
U
NEXT/YES
P
PRIOR/NO
Q
AREA
G
User Code
NOT USED