Nanni Q1500 Series, Руководство пользователя

Страница: 91 / 98

91
S10 STORAGE
CAUTION!
Packaged or not, the alternator must be stored in a cool,
dry place, protected from vibrations and never exposed
to the elements.
CAUTION!
Bearings require special maintenance, but it is advis-
able to rotate the shaft once or twice a month to prevent
fretting corrosion and grease hardening.
Engine restart
CAUTION!
Before starting the generator set, where regular lubri-
cation of the bearings is required, you should also lu-
bricate it.
WARNING!
After prolonged storage or if there are obvious signs
of moisture/condensation, check the condition of the
insulation. The insulation test must be performed by
a qualified technician. Before performing the test, you
must disconnect the voltage regulator. If the test result
is too low (less than 1 MΩ) (EN60204-1), you will need
to dry the alternator by blowing pressurized air at 50-60
C° into the alternator air inlets and outlets.
1. Clean the engine and check its condition.
2. Drain and replace engine oil.
3. Replace the oil filter.
4. Drain and replace the coolant.
5. Check the condition of the water pump rotor which
has been stored separately. Replace it if in doubt.
Reassemble the rotor
6. Remove the air intake covers. Check, dry and
clean the air box if necessary. Install the air filter if
equipped.
7. Check the hose clamps.
8. Check the coolant level. Adjust if necessary.
9. Put in place charged batteries.
10. Check the condition of the control cables and their
operation.
11. Check the condition of the belts. Adjust belt tension.
12. Drain the fuel tank.
13. Open the fuel system valves. Bleed the system
14. When the boat is in the water :
Open the through-hull and prime the raw water sys-
tem (if installed).
15. Start the engine. Check for leaks.