Nanni Q1500 Series, Руководство пользователя

Страница: 81 / 98

81
S08 ALTERNATOR
regulations of the country where the generator will be
installed.
CAUTION!
The final installer is responsible for the installation of all
protections (disconnecting devices, protection against
direct and indirect contact, overcurrent and overvoltage
protection, emergency stop, etc.), necessary for the
machine to comply with existing international / European
safety regulations.
The generator must be installed in a ventilated room. If
there is not enough air, malfunction or overheating may
occur.
All entrance doors to the generator room must be clearly
marked “Authorized Persons Only”.
Operating temperature
Maximum ambient
temperature to guarantee
the rated power :
40°C
Maximum operating
altitude to ensure
power rating:
Less than 1000 m
Install the alternator in a well ventilated area. Insufficient
ventilation can cause the alternator to overheat and
malfunction.
For required air volumes, see installation manual
DGBXXT13006A.
CAUTION!
If any components are changed, they must be replaced
with the original parts.
WARNING!
After long periods of storage or in the presence of
moisture/condensation, check the insulation condition.
The test must be performed by a qualified technician.
Before performing such a test, it is necessary to
disconnect the voltage regulator. If the measured values
are lower than those required (below 1MΩ) it is necessary
to remove the moisture by placing the alternator in an
oven at 50-60°C.