Myson iVector S2, Руководство по установке

Страница: 6 / 40

6
iVector S2
Installation manual
iVector S2 • 2022-07-01
US
Safety and general information
1.1 Safety information
This appliance MUST NOT be installed
in a bathroom or other similar high
humidity areas.
This appliance MUST be earthed.
This appliance must be installed by a
qualified installer.
The electrical installation must comply
with local or national wiring
regulations and should be carried out
by a qualified electrician.
This appliance can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
For the correct installation of this
product, it is essential that fixing
is carried out in such a way that
it is suitable for intended use and
predictable misuse. A number of
elements need to be taken into
consideration including the fixing
method used to secure it to the
surface, the type and condition of
the surface itself, and any additional
potential forces or weights that may
happen to be applied to the unit, prior
to finalising installation.
This product must not be installed
immediately below a socket outlet.
This product must not be installed in
areas where excessive dust exists.
This product can be hot when in
use, and as such, presents a risk of
burns to users on prolonged contact.
The temperature of the product
is dependent on system water
temperature, as set by the installer or
end user. Installers and users should
ensure that those who may come into
close proximity to the product are
aware of the risk of burns.
The imbedded iVector S2 VSI series do
not have a grille or covering plate. The
installer must provide safety guards
and air inlet/outlet grills to prevent
accidental contact with the device.
DO NOT cover or obstruct the air inlet
or outlet grilles.
Isolate electrical supply before
carrying out any cleaning or
maintenance activities.
This instruction leaflet is an integral
part of the appliance. The installer
MUST ensure it is left with the end
user.
All repair and maintenance activities
must be performed by suitably
qualified personnel.